Checklist for combined SOLISTA and LIBERO use
STEP 1:
Dig a hole in the sand and place the SOLISTA inside, ensuring the MYKITEMATE logo is aligned with the wind direction. The small red band in picture 1 indicates the wind direction.
STEP 2:
Cover the SOLISTA with sand, then flip its upper part over. Take the three green leashes and lay them out pointing towards where you intend to position your kite, which should be at a 90° angle from the wind direction, slightly upwind. This means you should place your ear directly into the wind and then look straight ahead when deciding where to place your kite. For stronger winds, consider digging a deeper hole to provide more stability for the SOLISTA.
STEP 3:
Move the kite to its launch position, connect the kite lines, and place the kite bar next to the SOLISTA’s three leashes as shown in picture 3.
STEP 4:
Thread the grey leash portion of the LIBERO through the three green D-rings of the SOLISTA as demonstrated in picture 4.
STEP 5:
Guide the LIBERO’s carabiner through the loop of the grey leash and tighten as shown in pictures 5 and 6.
STEP 6:
Attach your safety leash to the black D-ring on the LIBERO, choosing between the two available D-rings based on the length of your kite leash, as illustrated in pictures 7 and 8.
STEP 7:
Connect your safety leash carabiner to your kite bar (picture 9).
STEP 8:
Hook the LIBERO's carabiner to the kite bar's chicken loop (picture 10).
STEP 9:
Depower the kite, preparing it for launch. Move slightly upwind, ensuring the sand anchor is secure, before gradually moving downwind to the outer edge of the wind window until the kite is stable and ready for launching, as depicted in picture 11.
STEP 10:
Detach the safety leash from the black D-ring and secure it to your harness.
STEP 11:
Attach and secure the chicken loop to your harness, keeping the LIBERO's carabiner connected to the chicken loop as well (picture 13).
STEP 12:
Approach the sand anchor until the kite's pull is entirely transferred to you. Disconnect the LIBERO's carabiner from your chicken loop once everything is stable (picture 14).
STEP 13:
Power the kite and initiate the launch (picture 15).
Checklist for LIBERO launch
STEP 1:
Attach the LIBERO to a fixed object on the beach ( picture 1) and follow the same steps as the combined SOLISTA and LIBERO use, excluding steps specific to the SOLISTA.
.
Checklist for landing the kite
STEP 1:
Stand next to the anchor point.
STEP 2:
Gently land the kite at the edge of the wind window, away from the power zone, and release the kite bar once it's safely on the ground (picture 1).
STEP 3:
Connect the quick disconnect of the safety leash to the D-ring of the LIBERO (picture 2).
STEP 3:
Attach the carabiner of LIBERO to the chicken loop (picture 3).
STEP 4:
Depower the kite and approach it until all the kite's pull is transferred to the LIBERO (picture 4). Check for any movement of your sand anchor if using the combined system SOLISTA and LIBERO before detaching from the chicken loop.
STEP 5:
With the sand anchor stable and full tension on the LIBERO, disconnect the chicken loop from your harness (picture 5).
STEP 6:
Walk upwind towards your kite, grab it, turn it over, move a few meters towards your anchor point, then place it safely on the ground. It's recommended to secure the kite on the ground by adding sand behind the front tube like shown in pictures 6 to 8.
